Heat Pump excessive moisture? - heat pump troubleshooting
House is 2100 meters. Heat pump is again 1.5 years. The contractor has increased the size of the age of 3 tons to 3.5 tons of supposedly new. He installed an electrostatic filter active online Honeywell Model 1400 CFM Max. Armstrong unit outside with a scrolling news and a variable speed fan in the attic. Do not change the system of canals. From the floor to install the device had drops of moisture from outside into the auxiliary pan (which has no drainage), but never flown, or had enough to go fly. The entire area inside the coil is always wet in the spring, summer and autumn. The insulation is wet during this time. Wind records are the formation of moisture. The rust on galvanized metal pan begins. I'm worried that the internal components are the fan motor, control panels mail, not before time. I spent many hours in this and solution of problems to solve. How do I check to measure? Flow, pressure, temperature, and so on?
Heat Pump Troubleshooting Heat Pump Excessive Moisture?
3 comments:
The unit I have now is almost the same as what you say, you have now.
The cooling coils in a heat pump has to draw moisture to the defeat of a floating plastic bins and small pump water out of the house somewhere.
If you get moisture vents on the roof, you do not just take adequate insulation for the cooler air of the new unit.
As I said, we have something from the same unit or lifestyle, and Alabama. Hot this year was very hot and very, very wet. I have absolutely no problem with water to one of my openings.
But I had to isolate a three-fold when you install the device and performs the work.
If the primary cooling coil is not a good drainage and water collects there, so I could get the form of humidity, and work the explosion in the attic channel.
For a correct answer that I would call the company that installed it and went out and observe. Sounds like it could be an element of guarantee, because there are very significant issues with him are in 1.5 years
If the device is less than 2 years who may still be under warranty.
In this case, I would call the company that is installed in order to resolve these issues.
Production and Processing
Post a Comment